Standard Equipment
Ventilation and Control
--forced air circulation by quiet air turbine
--continuous adjustment of pre-heated fresh air admixture
--vent connection with restrictor flap
--microprocessor PID-temperature controller with integrated autodiagnostic system with fault indicator
--one Pt100 sensor class A in 4-wire-circuit
--integrated digital timer (1 min. up to 99 h 59min) to switch off heating to stand-by mode
--digital LED- display of set and actual temperature as well as remaining process time
--resolution of display for set value and actual value 0,5 °C
Overtemperature protection (double)
--in case of total breakdown of sensor, the heating is switched off at approx. 10 °C above set value
--in case of failure of the switching element, the heating will be controlled by an additional relay approx. 10 °C above the set temperature
--in case of a faulty sensor (incorrect measuring values) or the total breakdown of the controller the heating is switched off at approx. 10 °C above the max. oven temperature by the mechanical temperature limiter TB protection class 1
--for very sensitive and/or valuable load in terms of being non-reproducable, we recommend ovens of our E- and P-class guaranteeing an even higher safety standard
Textured Stainless Steel Casing
--w x h x d: 710 x 760 x 550 mm
--fully insulated stainless steel door with double locking and 4-point adjustment
--rear zinc-plated steel
Interior - Heating Concept
--w x h x d: 560 x 480 x 400 mm, 108 l
--easy-to-clean interior, made of stainless steel, reinforced by deep drawn ribbing with integrated and protected large-area heating on four sides
--2 stainless steel grids
Temperature Range
--from +30 °C (however, at least 10 °C above ambient) up to +220 °C
Voltage / Power Rating
--230 V (+/- 10%), 50/60 Hz
--ca. 2.000 W (during heating)
Packing Data
--net weight approx. 56 kg
--gross weight carton approx. 69 kg
--dimensions approx.: carton w x h x d: 82 x 97 x 67 cm
--the appliances must be transported upright
Accessories
--Perforated stainless steel shelf E0(x)
--Stainless Steel Grid E3(x)